ATAPIMO.FLT
Magneto-Optical (MO) device filter from Fujitsu
BASEDEV=ATAPIMO.FLT
- Note
- This driver can be substituted by the DANIATAPI.FLT
Parameters
- /Rn or /R:n - (Number of reserved drives) 'n' is a number between 1 and 10. Default is 1. A series of logical drive names can be reserved for each MO drive for future partitioning. If the number of valid partitions exceeds the number specified /R option, and if /S option is not specified, up to 16 partitions are allowed.
- /S - (Reserved drive priority) No more logical drives than the number of /R option is assigned. When the number of reserved drives specified with the /R option is fewer than the number of valid partitions on a disk, the number of reserved drives takes priority. For example, if there are four valid partitions on the disk and the number of reserved drives is specified at 3, a logical drive name cannot be assigned to the fourth partition, and hence it cannot be accessed.
- /I {h:} m {[n]} {+-{h:} m {[n]}}+-... - (Specify the drive ID) This parameter specifies the target MO drive by the host adapter number and SCSI-ID number. If this option is not used, all accessible MO drives are used by default. h is the host adapter number (between 0 and 9). The default is 0. m is the SCSI-ID number (0 to 7). n is the number of reserved drives. When 'n' is omitted, the value specified with the /R option is used.
- /U:{IDE adapter name} - (Required, specify IDE adapter driver) This parameter is not optional but required both for ATAPIMO.FLT and MODISK.DMD. You must specify same name for these two drivers. Usually '/U:ST506_HardDrive' works fine if 'IBM1S506.ADD' or 'IBM2S506.ADD' is used as IDE adapter driver.
| Product Support | |
|---|---|
| OS/2 1.3 | |
| OS/2 2.0 | |
| OS/2 2.1 | |
| OS/2 2.11 SMP | |
| OS/2 Warp 3 | C |
| OS/2 Warp Connect | C |
| OS/2 Warp 4 | C |
| OS/2 Warp Server for e-Business | C |