DBG_N_ModuleLoad

Debug Notification -8 - Module Load Notification

This notification returns:

• Cmd= DBG_N_ModuleLoad
• Value= MTE (Module Table Entry) handle of newly attached module
• Addr= 0

A module has just been loaded. This occurs either at program startup, or during a call to DosLoadModule.

The newly attached module's handle is returned via Value. You can use this handle with DosQueryModuleName, or with the Debug DBG_C_NumToAddr command, for symbolic debugging. A debugger should save these handles for future reference.

There may be many module attachments done at one time, but DosDebug is only able to communicate a single load during any one notification. In this case, the additional library load notifications become pending. The debugger should issue repeated DBG_C_Stop commands to be notified of these additional library loads, until Success is returned from the DBG_C_Stop command. If the DBG_C_Go, DBG_C_SStep, or DBG_C_RangeStep commands are issued instead of the DBG_C_Stop command, the pending notifications will be returned immediately, until there are no further notifications.