LOG.SYS
This driver enables logging of system error messages and some application error messages.
note: You need also logdaem.exe
DEVICE=C:\OS2\LOG.SYS <parameters>
Parameters:
- /E:value
This sets up the log buffer size. Value can be in the range from 4 to 64 . Default = 8 This value is expressed in Kbytes.
- /A:value
This is the size of the alarm buffer. Value can be in the range from 4 to 64 . Default = 8 This value is expressed in Kbytes.
- /OFF
If set to OFF the driver is installed but the logging of error messages is turned off. You can turn it on again with the program Syslog.
See the examples below.
To install the log driver with a log buffer size of 48 Kbytes and an alarm buffer of 16 Kbytes, add this line to your config.sys file:
DEVICE=C:\OS2\LOG.SYS /E:48 /A:16
To install the log driver but turn it off after initialization use this line:
DEVICE=C:\OS2\LOG.SYS /OFF
NOTE: LOG.SYS has its limitations. It will not log an application error unless the application has been written to make use of LOG.SYS. Some routine system errors will not log either because OS/2 opens an error message box on screen to report these.
Platform Support:
| OS/2 2.x | OS/2 3.0 | OS/2 4.0 | OS/2 4.5x |
|---|---|---|---|
| Yes | Yes | Yes | Yes |