|
|
| Line 1: |
Line 1: |
| Debug Notification -16 - Module Free Notification
| | #REDIRECT[[Debug Notifications]] |
| | |
| This notification returns:
| |
| * Cmd= DBG_N_ModuleFree
| |
| * Value= MTE (Module Table Entry) handle of freed module
| |
| * Addr= 0
| |
| | |
| A module has just been freed. This occurs either at program termination, or during execution of the DosFreeModule.
| |
| | |
| The newly attached module's handle is returned via Value. You can use this handle with [[DosQueryModuleName]], or with the DosDebug [[DBG_C_NumToAddr]] command, for symbolic debugging. A debugger should save these handles for future reference.
| |
| | |
| There may be many modules freed at one time, but [[DosDebug]] is only able to communicate the freeing of a single module during any one notification. In this case, the additional notifications of freed modules become pending. The debugger should issue repeated DBG_C_Stop commands to be notified of these additional module freeing operations, until [[DBG_N_Error]] is returned from the DBG_C_Stop command. If the [[DBG_C_Go]] or [[DBG_C_SStep]] commands are issued instead of the [[DBG_C_Stop]] command, the pending notifications will be returned immediately, until there are no further notifications.
| |
| | |
| [[Category:DBG_N]]
| |
| {{DISPLAYTITLE:DBG_N_ModuleFree}}
| |