View source for RODENT.SYS

Device driver for the shareware mouse driver Rodent. 
 DEVICE=\OS2\RODENT.SYS <parameter>

==Parameter==
;BAUD=#
:This option allows the baud rate to be specified. It may be one of
::150, 300, 600, 1200, 2400, 4800, 9600 or 19200
:All mice do not support all baud rates. To use the lowest baud rate supported by the mouse ;BUFFERED
:This option enables the FIFO buffer if a 16550 uart is detected.
;BUTTONS=#
:This option indicates the number of buttons to be supported. Many protocols support both 2 button and 3 button mice. This option may be specified as:
::BUTTONS=2
::BUTTONS=3
;COM=#
:This option allows the serial port to explicitly specified. This option may be specified as:
::COM=[1..4]
;DPI=#
:This option allows the mouse resolution to be specified in the range 100..640.
;FILTER=#
:This option is only effective for devices which can configure the device to discard marginal data points. The acceptable values are device dependent.
:* MOUSE=UN:  determines the number of values which are to be discarded after a touch. (0 to 99, default 20)
;FLIPXY
:Reverses the X and Y coordinates.
;IRQ=#
:interrupt number explicitly specified.
;MARGIN=#
:Margin on an absolute pointing device to be specified.
;MOUSE=xx
:mouse type
::MOUSE=AC - AceCat digitizers
::MOUSE=B - Buss mouse
::MOUSE=BP - Summagraphics Bit Pad digitizer
::MOUSE=C - Logitech Mouse System's compatible mouse
::MOUSE=CR - Summagraphics Bit Pad digitizer - Protocol: CR
::MOUSE=D3 - CalComp 3300 and newer digitizers
::MOUSE=D9 - CalComp 9x00 digitizers
::MOUSE=DW - CalComp WIZ and 2x00 digitizers
::MOUSE=KR - Kurta digitizers
::MOUSE=M - Microsoft compatible serial 2 button mouse, non-programmable
::MOUSE=MS - Mouse System's compatible serial 3 button mouse
::MOUSE=MW
::MOUSE=NM - Provides "no mouse" support.
::MOUSE=PS - PS/2 port compatible mouse
::MOUSE=S - only check for serial mice.
::MOUSE=SG - Summagraphics digitizers
::MOUSE=SM - Summagraphics digitizers 4-button puck or stylus
::MOUSE=SU - Summagraphics digitizers 16-button puck attached
::MOUSE=SX - Summagraphics FX digitizers
::MOUSE=V - Logitech compatible serial 3 button mouse, non-programmable.
::MOUSE=VW - Logitech's Microsoft/Mouse System compatible serial 3 button mouse
::MOUSE=UN - MicroTouch's UnMouse protocol
::MOUSE=*
;NAME=xx..xx
:name of the device driver. It defaults to "RODENT".
;NOISE=#
:adjust sensitivity to noise.
;ORDER=#
:button ordering.
;PRESSURE=#
:sets the pressure threshold
;PORT=#
:serial port address
;PROTOCOL=xx
:communications protocol
::PROTOCOL=3B - Three byte binary protocol
::PROTOCOL=5B - Five byte binary protocol
::PROTOCOL=BA - Summagraphics Bit Pad One/Two protocol
::PROTOCOL=BR - Summagraphics Bit Pad One/Two protocol relative
::PROTOCOL=BS - Buss mouse protocol, supports either 2 or 3 buttons
::PROTOCOL=CA - Summagraphics Bit Pad CR protocol
::PROTOCOL=CR - Summagraphics Bit CR protocol
::PROTOCOL=FA - Felix mouse protocol
::PROTOCOL=FR - Felix mouse protocol relative
::PROTOCOL=HA - CalComp high resolution binary digitizer protocol
::PROTOCOL=HR - CalComp high resolution binary digitizer protocol rel.
::PROTOCOL=IN - Inport buss mouse protocol, supports either 2 or 3 buttons
::PROTOCOL=MA - Summagraphics digitizer protocol
::PROTOCOL=MI - Microsoft compatible 2 button protocol
::PROTOCOL=MM - Mouse System's compatible protocol, supports either 2 or 3 buttons
::PROTOCOL=MP - Extension to MI protocol
::PROTOCOL=MR - Summagraphics digitizer protocol
::PROTOCOL=NM - Provides "no mouse" support
::PROTOCOL=RE - Relative Bit Pad One protocol
::PROTOCOL=PS - PS/2 port protocol, supports either 2 or 3 buttons.
::PROTOCOL=TA - MicroTouch's UnMouse tablet protocol
::PROTOCOL=TR - MicroTouch's UnMouse tablet protocol rel.
::PROTOCOL=UA - Summagraphics UIOF digitizer protocol
::PROTOCOL=UR - Summagraphics UIOF digitizer protocol rel.

;RATE=#
:reporting rate - 10, 20, 30, 40, 50, 60, 80, 100 or 200
;RESPONSE=#
:divisor to increase or reduce the mouse responsiveness. -8..8 defaults to 0.
;REVERSEX
:Reverses movement in the X direction.
;REVERSEY
:Reverses movement in the Y direction.
;SHARE
:share the irq if permitted by OS/2.
;UART=#
:UART type to be specified: 8250, 16450, 16550, 16550A, UART=16552
;X=[#..]#
:active horizontal range for a digitizer tablet.
;Y=[#..]#
:active vertical range for a digitizer tablet.

==Example==
 DEVICE=\OS2\RODENT.SYS PORT=73D8 IRQ=11 BAUD=2400 BUFFERED MOUSE=C PROTOCOL=MM
or
 DEVICE=\OS2\RODENT.SYS COM=1 MOUSE=* PROTOCOL=5B

{|class="wikitable"
|+
!OS/2 2.x
!OS/2 3.0
!OS/2 4.0
!OS/2 4.5x
|-
|Yes
|Yes
|Yes
|Yes
|}

==Links==
* [https://github.com/OS2World/DRV-Rodent Source Code at Github]

[[Category:DEVICE Statements]]